|
 |
| |
|
Instructions for Sludge Removal with Auto-Rx® |
|
For all engines with sludge. FOR BEST RESULTS, USE ONLYCONVENTIONAL OR ONE OF THE APPROVED SYNTHETIC OILS TO REMOVE SLUDGE. Most synthetic oils have a complex additive package that holds oil to metal, which also applies to sludge and therefore hinders the safe removal of sludge. Warning: The use of any oil not approved for Auto-Rx® will cause the sludge to return as though it had never been removed! See LIST OF APPROVED OILS here>> If you have questions about the application instructions, contact our technical support via email at technicalarx@gmail.com. Detail your problem, giving the make of vehicle, type of engine, mileage, oil used, etc. FOR QUESTIONS ABOUT ORDERS OR SHIPPING, contact Frank Miller at auto_rx@bellsouth.net or call 904-273-9098. |
| STEP 1 | Change oil and filter; then add Auto-Rx® at a ratio of 3 ounces per quart of oil to the crankcase with a fresh oil change and filter. Each bottle of Auto-Rx® contains 12 fluid ounces. If you recently had an oil change and are using conventional or an approved synthetic oil, go ahead and add Auto-Rx® to the oil already in the crankcase. |
| STEP 2 | Run the motor for 5 minutes or so to blend the Auto-Rx® into the host motor oil. For best results, run with conventional oil or an approved synthetic oil. |
| STEP 3 | Over time, drive the vehicle 2,500 miles with normal driving habits. About halfway through the first cleaning cycle at 1200-1300 miles,
change the oil filter only.  During Step 6 in the second cleaning phase, this may not be necessary (see NOTE below.) If
necessary, top off the oil (but do not add Auto-Rx® or
other additives); then finish the remaining 1200-1300
miles in the cleaning phase. |
| STEP 4 | Begin Rinse Phase: Drain the oil and refill with fresh oil and a new filter. Again, use conventional oil or an approved synthetic oil. |
| STEP 5 | Over time, drive 3,000 miles; then change the oil and filter again to complete the rinse phase. |
| STEP 6 | Begin Second Cleaning and Rinse: Repeat STEPS 1 THROUGH 5 to complete the sludge removal application. |
| STEP 7 | After completing Step 6, your sludge application is finished. Now add 2-3 ounces of Auto-Rx® with each oil change to keep the engine clean. You may use any oil you prefer. |
NOTE—CHANGE FILTER AT HALFWAY POINT: We recommend changing out the filter at the 1200-1300 mile mark because the oil filter can become loaded before completing the 2,500 miles. A fully loaded filter will go into the bypass mode whereby the filter is no longer capturing the contaminants, and the contaminants are then circulating throughout the oiling system. This is counterproductive and undesirable, as Auto-Rx® works best with maximum oil flow throughout the oiling system. In most cases, however, it will not be necessary to change the filter at the halfway mark during the second application of Auto-Rx®. To maintain a clean engine after an initial cleaning and rinsing, add just 2-3 ounces of Auto-Rx® with each oil change. This will provide additional cleaning over the long haul and will prevent having to clean the engine again down the road. |
|
Copyright 2002-2011. Auto-Rx Worldwide, Inc., Jacksonville Beach, FL USA. All rights reserved.
Site Design by WordPro
